瑞典蘭寶紫外燈MB3.0 Zeus L118電池版
瑞典蘭寶MB 3.0 紫外燈 Zeus、Hermes、Selene 和 Atlas 是具有強大而寬 UV-A 輸出的燈具,其范圍從 4 500 到 9 000 μW/cm2 不等。Zeus和Selene也為檢查后提供了強烈的白光。Hermes和Atlas對于在檢查期間不允許使用白光的組織沒有白光。
MB 3.0 Selene:9 000 μW/cm2,帶有強白光
MB 3.0 Atlas:9 000 μW/cm2,無白光
MB 3.0 Zeus:4 500 μW/cm2,具有強白光
MB 3.0 Hermes:4 500 μW/cm2,無白光
高品質UV-A LED,帶有白光塊濾光片,不會受到日曬的影響,根據型號的不同,覆蓋范圍超過8-9英寸/ 20-22厘米,并且重量低于許多同類產品。電源操作型號僅重 0.65 千克(1.4 磅),電池供電型號僅重 0.68 千克(1.5 磅)。它們廣泛用于現場檢查或MPI(Magnetic Particle Inspection磁粉檢驗)工作臺。 MB 3.0 系列型號均具有 IP68 防護等級。根據 IEC 62471,上述四個型號均具有 3 級風險等級。
請注意,在小型外殼中,將多個UV LED安裝在彼此相距幾毫米以內的普通UV燈會產生過多的熱量,從而顯著縮短LED的使用壽命。由于外殼小,LED數量多,您無法觀察到LED失效,因為仍然有一些光出來,盡管正在迅速減弱,無法驗證是否符合ASTM E3022以及NADCAP檢查表。ASTM E3022要求在使用前更換關鍵組件,例如故障LED。
美國軍方成員應該要求MB 3.0 Atlas(交流供電的PN:L125,電池PN:L124)。MB 3.0 阿特拉斯電池與雅典娜噴霧罐持有人附加攜帶PN:L126。
MB 3.0 Zeus UV手持設備也是INSPECTOR KIT(PN:K001)的一部分,該套件還包括UVG5 2.0 Midlight 紫外線頭燈,UVG3 2.0 Midlight UV紫外線手電筒和Apollo 2.0 紫外照度計。美國空軍應該要求K002。
瑞典蘭寶MB 3.0 紫外燈有四種不同的MB 3.0型號,Zeus,Hermes,Selene和Atlas,產生不同的強度并經過測試以符合許多無損檢測標準。4種型號均采用電池供電和/或交流(電源)供電,峰值為365nm。許多安裝附件可用于 AC(電源)或電池版本。宙斯和塞勒涅也配備了白光。
here are four MB 3.0 Series models, Zeus, Hermes, Selene and Atlas. Depending on the model, the beam diameter is 8-9 inches / 20-22 cm and with intensities that vary from ≈ 4 500 to 9 000 μW/cm2. Zeus and Selene are equipped with a strong white light as well. Spray can holder accessory Athena is available factory installed or as a later addition (PN: A503).
瑞典蘭寶MB 3.0 紫外燈Zeus (PN for AC (Mains) – L118, PN for Battery – L119, PN for Battery with Athena – L122):經過測試,符合ASTM E3022-18和ISO 3059-12標準以及勞斯萊斯工程規范RRES 90061和空中客車AITM6-1001測試方法。它在38厘米(15英寸)處產生約4 500μw/cm2的強度,并配有白光LED,用于檢查后。電池版本的運行時間為3.5小時。它是IP68,具有穿透性。超過1 000 μw/cm2生成的光束尺寸約為9英寸/22厘米。
LABINO MB 3.0 Zeus (PN for AC (Mains) – L118, PN for Battery – L119, PN for Battery with Athena – L122): has been tested to comply with both ASTM E3022-18 and ISO 3059-12 standards as well as the Rolls-Royce Engineering Specification RRES 90061 and Airbus AITM6-1001 Test Method. It generates an intensity of approximately 4 500 μw/cm2 at 38 cm (15 inches) and is equipped with a white light LED for after inspection . The running time of the battery version is 3.5 hours. It is IP68 and is penetrant resistant. The beam size generated above 1 000 μw/cm2 is approximately 9 inches / 22 cm.
瑞典蘭寶MB 3.0 紫外燈 Hermes交流電源的PN - L121,電池PN - L120,Hermes電池的PN - L123:已經過測試,符合ASTM E3022-18和ISO 3059-12標準以及勞斯萊斯工程規范RRES 90061和空中客車AITM6-1001測試方法。它在 38 厘米(15 英寸)處產生約 4 500 μw/cm2 的強度。它沒有白光LED。電池版本的運行時間為3.5小時。它是IP68,具有穿透性。超過1 000 μw/cm2生成的光束尺寸約為9英寸/22厘米。
LABINO MB 3.0 Hermes (PN for AC (Mains) – L121, PN for Battery – L120, PN for Battery with Athena – L123): has been tested to comply with both ASTM E3022-18 and ISO 3059-12 standards as well as the Rolls-Royce Engineering Specification RRES 90061 and Airbus AITM6-1001 Test Method. It generates an intensity of approximately 4 500 μw/cm2 at 38 cm (15 inches). It does not have a white light LED. The running time of the battery version is 3.5 hours. It is IP68 and is penetrant resistant. The beam size generated above 1 000 μw/cm2 is approximately 9 inches / 22 cm.
瑞典蘭寶MB 3.0 紫外燈Selene交流電源的PN - L139,電池的PN - L138,selene電池的PN - L140:已經過測試,符合ASTM E3022-18和ISO 3059-12標準。它在38厘米(15英寸)處產生約9 000μw/cm2的強度,并配有白光LED,用于檢查后。電池版本的運行時間為2.5小時。它是IP68,具有穿透性。超過1 000 μw/cm2產生的光束尺寸約為8英寸/20厘米。
LABINO MB 3.0 Selene (PN for AC (Mains) – L139, PN for Battery – L138, PN for Battery with Athena – L140): has been tested to comply with both ASTM E3022-18 and ISO 3059-12 standards. It generates an intensity of approximately 9 000 μw/cm2 at 38 cm (15 inches) and is equipped with a white light LED for after inspection . The running time of the battery version is 2.5 hours. It is IP68 and is penetrant resistant. The beam size generated above 1 000 μw/cm2 is approximately 8 inches / 20 cm.
瑞典蘭寶MB 3.0 紫外燈 Atlas交流電源的PN - L125,電池的PN - L124,altlas電池的PN - L126:已經過測試,符合ASTM E3022-18和ISO 3059-12標準。它在38厘米(15英寸)處產生約9 000μw/cm2的強度。它沒有白光LED。電池版本的運行時間為2.5小時。它是IP68,具有穿透性。超過1 000 μw/cm2產生的光束尺寸約為8英寸/20厘米。
MB 3.0 系列產品經過專門設計,可滿足 ASTM E3022-18 和 ISO 3059-12 標準以及 PRIMES 設定的要求。MB 3.0 系列中使用的光學元件符合勞斯萊斯 RRES 90061 規范。紫外光的光束輪廓非常均勻,沒有從LED、陰影、黑點或其他令人不安的缺陷中顯示任何足跡。
LABINO MB 3.0 Atlas (PN for AC (Mains) – L125, PN for Battery – L124, PN for Battery with Athena – L126): has been tested to comply with both ASTM E3022-18 and ISO 3059-12 standards. It generates an intensity of approximately 9 000 μw/cm2 at 38 cm (15 inches). It does not have a white light LED. The running time of the battery version is 2.5 hours. It is IP68 and is penetrant resistant. The beam size generated above 1 000 μw/cm2 is approximately 8 inches / 20 cm.
上圖為瑞典蘭寶MB 3.0 紫外燈電源版本的配置
上圖為瑞典蘭寶MB 3.0 紫外燈電池供電版本的配置